hobDrive Support

Hi Just wondering if you software will work on the following unit;

http://cgi.ebay.com.au/ws/eBayISAPI.dll ... 075wt_1140

what sort of connector would you recommend usb or bluetooth and if so are any in particular more suited to your software?

regards,

steve

Hi Steve,

It will, but you'll have to solder an external USB-host connector to it. Read the appropriate thread on this topic.

There could be a chance such a connector already exist on this unit (in that case it is normally referenced as "3G modem ready"). But from information above I have not found any references of it.

Both BT and USB ELM adapters will work fine as soon as you'll get a USB-host connector